h22a motor rebuild

[one_race]

im looking to rebuild a h22a to take 30psi and about a 75-150 wet shot but i cant find a good rebuild kit. im throwing it in a del sol. also what you be your labor to put all this in. im getting the hmotorsonline.com h22 complete change over.

[levee000]

sleeved,rods,pistons my buddy is havin revline do his right now :thumbsup: and maybe head work but bottum end build is 3500 i think from wat my friend said


and chuong is a B series man :lol2:

[codyellis]

I hope you have a bank account with over 5 figures.

[volk]

30 psi huh?

[Wleach11]

Does it just have to go "ONE_RACE" I'm guessing your new to the Honda thing. Because your going to spend ass loads of money to build that set up and then you'll spend ass loads getting it in the car, Then even more trying to get it to hook.

If this is what your going to do then a side job as a bank robber will probably be a good idea.

[one_race]

Does it just have to go "ONE_RACE" I'm guessing your new to the Honda thing. Because your going to spend ass loads of money to build that set up and then you'll spend ass loads getting it in the car, Then even more trying to get it to hook.

If this is what your going to do then a side job as a bank robber will probably be a good idea.

just a few races to find out what it would run. but 3500 is alot so that plan kinda failed. so NEVER MIND. not trying to go over 8 grand for this

[levee000]

go big or go home sounds like ur goin home lol :lolg:

[Dester223]

Our basic prices on bottom end rebuilds:

If you bring us a bottom end with a good block/crank/mains.

We throw in CP pistons/eagle rods
new oil pump
new water pump
new ACL bearings
all new gaskets in the bottom end
send it to our machine shop to have the bore/hone
assemble. is 2,000

Our package for a sleeved block (which in your case you have an H22 and you would need to do) is 3,000

Head work
head gasket
headstuds cost more.

Also, you are building an h22, there are other things that that engine requires that a typical b/d series doesn't have.

If your goals are to run 30 psi and over a 100 shot of nitrous, your expected spending limit of 8k will probably not get you very far to have parts that will last.

[one_race]

Our basic prices on bottom end rebuilds:

If you bring us a bottom end with a good block/crank/mains.

We throw in CP pistons/eagle rods
new oil pump
new water pump
new ACL bearings
all new gaskets in the bottom end
send it to our machine shop to have the bore/hone
assemble. is 2,000

Our package for a sleeved block (which in your case you have an H22 and you would need to do) is 3,000

Head work
head gasket
headstuds cost more.

Also, you are building an h22, there are other things that that engine requires that a typical b/d series doesn't have.

If your goals are to run 30 psi and over a 100 shot of nitrous, your expected spending limit of 8k will probably not get you very far to have parts that will last.

thats why i pretty much kicked my h22 dream to the curb. might just have to keep the fox.