price on install parts in a gsr

[bgpmpn]

hi i have d valve springs and t retainers and i was wondering how much it would to get them installed.i was also wandering about a good set of cams i was thinking like skunk2 or something thats has great power, and cam gears. i also need a intake manifold and 70mm tb how much do they run, i also have rc 310 injectors put in to and need it tuned.. ok this is what im working on its a 93 si hatch with a full gsr swap with jdm itr pistons and heat treated itr rods and usdm itr cams with stock gears it has a stock gsr tune on a hondata s200 from California if you could give me a price that would be great thanks jason

[Dester223]

Dual Valve Springs and retainers would run 350 installed in the car, no extra $ for camshaft or cam gear installation since most of that will have to come off.

You'll need 2 new cam seals.

We can get skunk2 camshafts, skunk2 intake manifolds and a couple different throttle bodies.

If you have time, swing on down to the shop and we'll get you a full price estimate on everything that you're wanting to get done.
-Chuong

hi i have d valve springs and t retainers and i was wondering how much it would to get them installed.i was also wandering about a good set of cams i was thinking like skunk2 or something thats has great power, and cam gears. i also need a intake manifold and 70mm tb how much do they run, i also have rc 310 injectors put in to and need it tuned.. ok this is what im working on its a 93 si hatch with a full gsr swap with jdm itr pistons and heat treated itr rods and usdm itr cams with stock gears it has a stock gsr tune on a hondata s200 from California if you could give me a price that would be great thanks jason

[bgpmpn]

well i kinda live in salina ks would the itr valve springs hold the skunk2 stage 2 cams

[bks84]

well i kinda live in salina ks would the itr valve springs hold the skunk2 stage 2 camsGive him a call... 816-221-4411

[Dester223]

well i kinda live in salina ks would the itr valve springs hold the skunk2 stage 2 cams

It's not recommended. You need better springs than the ITR setup for skunk2 stage 2 cams.

I'll try to get a complete list and PM you prices.

[bgpmpn]

ok thanks

[Dester223]

PMed ya.