DYNO Stock OBD0 B16 with intake 140hp/103tq

[Dester223]

Engine: OBD0 B16 Swap

Setup: Stock with short ram intake and crush bent exhaust setup. I am pretty sure this was on the stock exhaust manifold

Tuned with OBD0 TurboEdit:

http://www.we-todd-did-racing.com/files/1048468_fktq2/JeremyB16.JPG

[ChickenFlava]

I thought you guys didnt tune OBD0 cars?? :confused: .. i have the same engine...... are you guys able to tune it?? it is mildly built..

[beaterKU]

TurboEdit FTW. I didn't know people still used it. Rock on, William would be proud

[Dester223]

That was a PR3 ecu and we used turbo edit to do the NA tune on it. It takes a bit longer than OBD1 stuff, but it's possible.

And yes, turboedit is pretty neat stuff.

[ChickenFlava]

I have a chipped PR3 too... :) ... ill swing by the show pretty soon, i need some stuff done..

[Dester223]

I have a chipped PR3 too... :) ... ill swing by the show pretty soon, i need some stuff done..

http://www.jeboavatars.com/images/avatars/5390794064orly%20owl.jpg

Sorry, I found it fitting :)

[zero2326]

I recommend Chuong to tune a persons car he brings good results

[Jsk20r]

where those numbers whp or to the crank? No bad though!